43 Years Emblem


E-mail:
Info@BobsCB.com

Info Line:
814-379-3003

Order Line:
800-473-9708

Mail & Shipping:

Bob's CB Shop
21232 Route 322
Strattanville, PA 16258

Located Across
The Road From
The All American
Plaza I-80 Exit 70

Store Hours:

Mon-Fri 8AM - 8PM
Sat 8AM - 4PM
Sun 10AM - 6PM

 

The Galaxy DX 95T2 10 Meter Mobile Transceiver From Galaxy.

 


Galaxy DX 95T
2 10 Meter Mobile Radio


Thermostatically controlled  fan head the list of  fresh new ideas that make this our most feature-packed radio.

Click photo for large view.

$439.95

Galaxy DX 95T2

Noteworthy features include :

 

bulletA High-Performance output circuit that uses two Toshiba 2SC2290 power transistors to generate 50 watts for AM/FM and 150 watts for SSB operation
bulletChassis incorporates a solid aluminum finned rear section as a heatsink
bulletAdditional heat sink on the bottom of the radio with an internal Micro cooling fan increases the radio height from 2.5 to 3 inches
bulletSame main circuit board as our DX 2517, DX 93T, DX 48T and DX 45MP
bullet"StarLite" faceplate is matte black with all lettering backlit in green and blue
bulletSwitchable sixth digit provides five or six digit frequency display
bulletOur exclusive "SuperSlider" circuit maximizes frequency control by switching the Fine clarifier between Receive/Transmit and Receive Only operation or completely out of the circuit with one slide switch. The Coarse clarifier operates on both receive and transmit unless the SuperSlider switch is off. When switched off, both clarifiers are out of the circuit.
bulletRetro-look red modulation lamp (with On/Off switch) flickers like the old neon lamps of the Fifties and Sixties
bulletThere is a receive gain variable control on the DX 95T2.
bulletFront mic jack
bulletVariable power output control
bulletRed channel and frequency digits
bulletHeavy duty DC power cord

Strange and Unusual Features:

bulletThe echo has internal controls only. It is our famous dual control echo circuit without any controls on the front panel. The On/Off switch is there, but to adjust the echo sound, the bottom cover must be removed. Locate the rectangular metal box containing the echo board. Do not open this box. Use a small plastic tuning tool to gently adjust the trimmer pots inside the holes marked "ECHO" and "TIME." These pots are somewhat fragile so it is best not to use a metal screwdriver.
bulletA single slide switch controls both the Echo and the Roger Beep. They can both be off, but they cannot both be on at the same time.

The DX 95T2 also has the following standard features found on most other Galaxy radios :

bulletLarge, easy-to-read meter with 4 scales:
  1. "S" meter indicates up to 60dB over S9
  2. Modulation percentage scale for use on AM
  3. Calibrated power scale
  4. SWR scale
bulletAutomatic SWR circuit (No complicated calibration procedure required)
bulletLED's light red to warn of high SWR
bulletTalkback circuit with On/Off switch and volume control
bulletVariable dimmer control pot
bulletOn/Off switch for frequency display
bulletRoger Beep circuit
bulletNB/ANL circuit
bulletMeter glows red during transmit
bulletTwo year limited warranty
bulletMeter glows red during transmit
bulletNB/ANL circuit with green LED indicator
bulletTwo year limited warranty
 

Content And Code Copyright© Bob's CB 1999-2008